Guide to Installing Shower Screens for Bathroom Upgrades

Imagine transforming your bathroom only to find water splashing everywhere because the shower screen installation seems daunting? Worry not—installing shower screens is simpler than you might think. This comprehensive guide will walk you through the process step by step, whether you're creating a walk-in wet room or adding protection to your bathtub.

Proper preparation is crucial for a smooth installation process and to avoid potential issues.

• Check all included parts: glass panels, wall brackets, support arms (for some models), screws, wall plugs, and sealing strips.
• Review the product manual to understand each component's purpose and installation sequence.

• Power drill (with hammer function for tiled/concrete walls)
• Screwdriver set
• Tape measure
• Spirit level
• Pencil for marking
• Silicone sealant gun
• Utility knife
• Cleaning cloths
• Safety glasses and work gloves

• Ensure walls and floors are level and structurally sound
• Verify there are no hidden pipes or wiring in drilling areas
• Maintain good ventilation during installation
• Clear the work area of obstructions

Walk-In Screens: For open wet room designs, requiring careful waterproofing and floor gradient planning.

Bath Screens: Mounted on tub edges, available in single/multi-panel folding or sliding configurations.

Use a spirit level to check the shower base or floor. Uneven surfaces require correction before proceeding.

1. Position brackets aligned with the shower base edge
2. Mark drilling points through bracket holes
3. Drill holes (use tile drill bits for ceramic surfaces first)
4. Insert wall plugs flush with the surface
5. Secure brackets firmly with screws

1. Carefully lift panels into position (two-person job recommended)
2. Engage panels with bracket channels
3. Secure using provided screws or clamps

1. Position arms between panel top and wall
2. Cut to length if necessary
3. Mount to wall and connect to glass

1. Clean all joints thoroughly
2. Apply waterproof silicone evenly
3. Smooth with a damp finger or tool
4. Allow 24+ hours curing time

Ensure the bathtub rim is perfectly horizontal using a spirit level.

Follow the same bracket mounting and panel installation principles, adjusting for tub dimensions.

• Safety: Always wear protective gear during installation
• Measurement: Triple-check all dimensions before drilling
• Common Issues:
  • Ill-fitting panels - verify measurements before purchase
  • Loose brackets - use appropriate wall plugs
  • Leaky seals - ensure continuous silicone application

• Regularly clean with non-abrasive products
• Inspect silicone seals annually
• Maintain bathroom ventilation to prevent mold
• Avoid harsh cleaners that damage glass coatings